Suspension Springs & Spring Struts
To replace suspension springs and struts safely, you need a spring compressor that matches the spring and your toolkit. Check the drive size: 1/2 or 3/4 inch is typical. A socket set usually contains multiple sizes for different strut nuts. The compressor capacity should handle at least 1500 kg. Always use a safety cable or spring holder to prevent the spring from releasing suddenly.
Spring Strut Set | 4 pcs.
Spring Compressor Set | 1500 kg
2 pack sizes
1-2
Safety Wire for Spring Compressor products 1134, 1144
Spring Support "Plus" | for BGS 1134, 1144 | with protective insert | Ø 80 - 200 mm
Shock Absorber Counter holding Wrench | for Shock Absorbers with Oval Pins
Shock Absorber Tool Kit | 39 pcs.
Special counterholding Bit | internal Hexagon 5 mm
Special counterholding Bit | internal Hexagon 6 mm
Bit | Length 93 mm | 10 mm Drive | T-Star (for Torx) T50
Shock Absorber Tool Kit | 18 pcs.
2 pack sizes
1-2
Bit Socket | 12,5 mm (1/2") Drive | internal Hexagon 6 mm
Bit Socket | 12,5 mm (1/2") Drive | internal Hexagon 7 mm
Bit Socket | 12,5 mm (1/2") Drive | internal Hexagon 8 mm
Bench Vice Clamping Tool | for Struts
Spreader Socket for Spring Strut Clamps | 12.5 mm (1/2") Drive | 5.5 x 8.2 mm
Spreader Socket for Spring Strut Clamps | 12.5 mm (1/2") Drive | 5 x 7 mm
Spreader Socket Set for Spring Strut Clamps | 12.5 mm (1/2") Drive | 5 x 7 mm + 5.5 x 8.2 mm | 2 pcs.
Spring Strut Set | 8 pcs.
Strut Nut Wrench & Holding Tool | for Volvo
Shock Absorber Wrench | for Shock Absorber Screwing on Mercedes-Benz
Shock Absorber Tool Kit | for Shock Absorbers with Stop Spring | 8 pcs.
Spring Strut Socket | 13 mm | for VAG
2 pack sizes
1-2
Subframe Alignment Pin Set | for Ford
Strut Spreader Tool
Safe Work on Springs and Struts
Choose the right spring compressor
Replace coil springs and struts only with a spring compressor that fits the spring. Check the clamping capacity. It must be at least 1500 kg. That holds the spring securely and keeps you safe. A set with different hooks is handy. It handles both straight and tapered springs.
Check sizes and drives
Strut nuts come in different sizes. A socket set with multiple hexagon sizes prevents you from getting stuck. Also check the drive of your ratchet. 1/2 inch is common, 3/4 inch for heavier work. Measure the nut before you order. That way you know the socket fits.
Prevent the spring from flying off
A spring is always under tension. Release it carelessly and it can fly off. Always use a safety cable or a spring holder. It keeps the spring in place, even if the compressor fails. A holder with a protective sleeve prevents damage to the spring. This keeps the job safe and clean.
This tool belongs with work on gearbox, axles & steering. If you also need new bearings or rubber bushes, take a look at wheel bearings & rubber bushes. For work on drive shafts & wheel hubs and on ball joints you will find the matching tools there. And before you put the car on the lift, reach for your wheel mounting first.