Spare parts
Spindles and pressure pieces for screw clamps, striking inserts and handles for hammers, blades for gasket cutters, hollow punches for punch sets and the small parts that make a tool complete again. Puller parts are listed under pullers.
KUKKO 8-150 Extension 150 mm for 8-HP, Aluminium
KUKKO 9-2-ERS Repair parts for hydraulic auxiliary presses 9-2, K-20-15
KUKKO 71-SH-C Impact sleeve for bearing installation tool set 71 -C-
KUKKO 71-SH-E Impact sleeve for bearing installation tool set 71 -E-
KUKKO 103-162 Wrench for clamping jaw 103-160
KUKKO 106-202 Wrench for clamping jaw 106-200
KUKKO 128-DS-36 Part for KUKKO system for repair work on control arms VW T4, Ø 36x14 mm
KUKKO 128-DS-40 Replacement part for KUKKO system for repair work on the control arm VW T4, Ø 40x8 mm
KUKKO 128-DS-52 Spare part for KUKKO system for repair work on control arms VW T4 Ø 52x22mm
KUKKO 525-101 Interchangeable pipe jaws for parallel vices 525-100
KUKKO 525-126 Interchangeable pipe jaws for parallel vices 525-125
KUKKO 525-177 Turn plate for vice
KUKKO 550-135 Aluminium vice jaws 135 mm
KUKKO 700117 Pressure pieces (sets) for 70-01
KUKKO 3008028 Functional insert for "SELECTHOR" Ø 80 mm
KUKKO GA12-1515 Thread adapter
KUKKO GA1615-21 thread adapter
KUKKO T-AW-40-M Magnetic sensor for inductive bearing heaters T-AW-40
KUKKO VM10-12 Connecting nut VM10-12
KUKKO VM1815-58 Connecting nut VM1815-58
KUKKO Y518-09-P Pair of support nuts for pulling bolts
KUKKO Y518-33 Quick-coupling nut
KUKKO YRE-101-K Seal kit for Hydraulic pressure cylinder with collar thread YRE-101
KUKKO 71-L-H-A Impact sleeve for bearing fitting tool set 71-L -A-
Spare Parts for Your Workshop Tools
Choose the Right Part for Your Tool
Spare parts come in many sizes and versions. Always check the size of the part you need. Measure the diameter of a drill bush or the thread size of a spindle. This prevents ordering the wrong part. If the size is not in the product description, measure the original part.
Where Ordering Goes Wrong
Many parts look similar but differ in detail. A pressure piece for a glue clamp does not fit another clamp automatically. The across flats of a nut or the length of a spindle also determine if a part fits. Always check the type number of your tool. Only then you know the part will fit.
Quality and Standards
Tools must work safely. Therefore, some parts are bound to standards, such as DIN 3113 for adjustable wrenches. Always use parts that meet the same standard as your original tool. This keeps your tool reliable and safe. Replace worn parts in time; it extends the life of your tool.
Looking for the tools these parts belong to? Take a look at hand tools, clamps and tensioners or striking and marking. You will also find matching parts at punches, extractors and shears.