Cutter for saddle tap 50 to 63 mm

The cutter that makes the hole in the pipe for a saddle tap. It cuts at the diameter the saddle seal relies on and leaves a clean edge.

Always run it through the drill jig and never freehand. A hole a few degrees out lets the O-ring lift on one side, and that leak then sits under a saddle you have just clamped around it.

Specifications

• Suitable for: 50 to 63 mm
• Material: steel
• Working pressure: vacuum to 16 bar
• Temperature range: -20 to +80 °C
• Medium: compressed air and vacuum
• Series: Aignep Infinity
• Manufacturer: Aignep, Bione (Italy)