Sanders
Pneumatic grinders for grinding, polishing, and cutting off. Choose from straight or angled models. The length determines reach, the maximum RPM the working speed. Watch air consumption and noise output. An undersized compressor reduces performance. Check the air inlet thread and working pressure before you order. This helps you select the right grinder for your workshop.
Die Grinder | short | 170 mm
Cutting Disc for BGS Reversible Corner Grinder | Ø 105 x 1.5 x 16.2 mm
Air Cutter | extra long | flat Head | 376 mm
Die Grinder | 90° angled | 155 mm
Die Grinder Head Repair Kit | for BGS 3269
Die Grinder | 340 mm
Pneumatic Multi Grinder Set
Wire Brush | straight | Ø 103 x 23 x 0.5 mm
Wire Brush | bent | Ø 103 x 23 x 0.5 mm
Wire Brush | bent | Ø 103 x 23 x 0.7 mm
Sanding Wheel for BGS 3274 | Ø 115 mm
Eraser Wheel for BGS 3274 | Ø 105 x 30 x 53 mm
Air Cutter | 75 mm
Cutting Disc | Ø 75 x 1.8 x 9.7 mm
Air Cutter | extra long | 310 mm
Hook and Loop Pad for BGS 3290 / 8688 | Ø 150 mm
Air Eccentric Angle Sander / Burnisher
Hook and Loop Pad for BGS 3291 | Ø 30 mm
3 pack sizes
1-2
Air Bristle Grinder Set | 17 pcs.
Air Eccentric Grinder
Hook and Loop Pad for BGS 3290, 8688 | Ø 152 mm
Air Belt Grinder for 10 mm Sanding Belts
Grinding Belt Set | for BGS 8853 | 10 mm x 330 mm | K 60 - 80 - 120 | 12 pcs.
Die Grinder | extra short | 120 mm
How to choose the right air grinder
Straight or angle, which version fits?
A straight air grinder works best for precise tasks in a straight line. An angle version reaches tight spots and suits cutting off. The length determines your reach. Short tools around 170 mm give control. Extra long versions up to 376 mm reach deeper into engine bays or between chassis parts.
Watch RPM and working pressure
The maximum RPM sets how fast you grind or polish. Higher speeds work quicker but need more air. Compare the tool's air consumption with your compressor's output. A small compressor cannot deliver enough pressure. The tool loses power and the job takes longer. The required working pressure is often stated in bar or psi.
Where ordering goes wrong
Check the air inlet thread. Most tools use a 1/4 inch female thread, but exceptions exist. Measure the collet or arbor size too. A straight grinder often takes a 6 mm collet, a cut-off tool an arbor of 16.2 mm. If the fitting does not match, the tool will not run. Consider noise and vibration for long sessions. Pick a version with lower noise levels then.
These sanders fall under air tools for the workshop. Use them on bodywork and they pair well with spray guns. For rust and paint choose sandblasting equipment, and with air blow guns you blow away swarf. Make sure your air tool accessories and hoses fit your connection.