Cable Lugs
You need end terminals to connect battery cables and heavy wiring. You can buy them loose or as an assortment. A compact set is fine for occasional work. For daily use, choose a comprehensive case. Most cases come with a hanging bracket. That keeps them within reach on your workshop wall. Check the IP rating as well. A sealed case protects against dust and moisture. Always match the terminal size to your cable gauge. The wrong size gives a poor connection.
Ferrules Assortment | insulated | 685 pcs.
Cable Lug Assortment | 30 pcs.
3 pack sizes
1-2
Branch Connector Set | 50 pcs.
Soldering Connector Assortment | with Shrink Tube | 9 pcs.
3 pack sizes
1-2
Ferrules Assortment | insulated | 93 pcs.
End terminals for every cable size
End terminals for every cable size
End terminals connect power cables safely to battery posts, earth points or distribution blocks. You choose a loose terminal or an assortment. A small set is enough for occasional work. A large set is suitable for the workshop. Always check the size of the terminal. It must match the cable diameter. A terminal that is too small does not clamp properly. A terminal that is too large gives a poor contact.
Where ordering goes wrong
The biggest mistake is choosing a set without checking which diameters it contains. End terminals have a stated range for the cable diameter. Check this range before you order. Also look at the insulation. Insulated terminals prevent short circuits on cables that run close together. Uninsulated terminals are for areas with enough space. Heat shrink adds extra protection against moisture.
Protection and storage
The IP rating keeps dust and moisture out. This keeps end terminals clean and dry. Store them in the case that comes with the assortment. The cases have hanging brackets. Fix them to the wall for a quick overview. This way you find the right size immediately. After crimping, test that the connection is secure. Pull on it with reasonable force. A good connection shows no movement.
End terminals belong with consumables in the workshop. Tie loose cables neatly together with cable ties and protect the cores with insulation and adhesive tapes. For a safe circuit you choose the right fuses.